Lie Detector electronics Kit

Availability: In Stock
Brand: Madlabs
Product Code: Lie Detector

Lie Detector electronics Kit

This circuit is based on the fact that a person's skin resistance changes when they sweat (sweating because they're lying). Dry skin has a resistance of about 1 million ohms, whereas the resistance of moist skin is reduced by a factor of ten or more.

The MadLab electronics range is divided into beginners kits which are suitable for people with only a little practice at soldering, medium kits which require a higher level of soldering skill for people who are more experienced, and advanced kits for expert constructors and crazy experimental musician circuit benders.

Every MadLab kit includes a professionally-manufactured printed circuit board, quality electronic components and full assembly instructions. (Think Ikea - Airfix!)

Resistors R1 and R2 form a voltage divider. They have resistances of 1 000 000 ohms (1 mega ohms) and, because their values are equal, the voltage at the upper probe wire is half the battery voltage (about 4.5 volts).

A person holding the probe wires will change the voltage at the upper probe wire depending on their skin resistance. The skin resistance is in parallel with R2 and, because it is likely to be similar to or smaller than R2, the voltage at the probe wire will fall as skin resistance falls.

Capacitor C1 functions as a smoothing capacitor and removes the 50Hz induced mains hum that is found on a person's body.

TR1 and R3 form a buffer circuit (called an emitter-follower). The voltage at the emitter of TR1 follows the voltage at the probe wire and is now able to drive transistor TR2.

Transistors TR1 and TR2 act as a voltage comparator. If the voltage at the base of TR2 is higher than at the base of TR3 then the green LED (L1) will come on. If the reverse is true then the red LED (L2) will light.

To test the Lie Detector hold the probe wires. Adjust VR1 until the green LED is just on and the red LED is just off. This is the point at which the voltage at the base of TR2 is just greater than at the base of TR3. Now use moist fingers to hold the probes. This lowers the skin resistance and causes the voltage at the base of TR2 to fall. The voltage at the base of TR3 is now greater and the red LED comes on

Reviews about Lie Detector electronics Kit
Average rating: 0 reviews
Total reviews: 0
Write your own review on this product.
Write a review
Sort by:

Write a JOYO user review

Review Title

Your Name:

Your Review: Note: HTML is not translated!

Add prosAdd cons
I would recommend this product to a friend?

Enter the code in the box below:

Delivery & Postage

Despatched within 1-2 working days via options available on checkout. Select from Royal Mail, Tracked, Interlink DPD & International.

All items are despatched direct from the JOYO Audio UK warehouse in Manchester England.

UK Recorded


International Postage EU & Rest of World.

Related Products

  • Current

Other (write below)